Key Features:

Module Type: Safety input expansion module

Compatibility: Designed for FX3 safety controllers

Safety Rating: Performance Level e (PL e) according to ISO 13849-1, SIL 3 according to IEC 62061

Number of Inputs: 8 safe inputs

Input Type: Dual-channel (tested) inputs

Configuration: Software-based via SICK Safety Designer

Operating Voltage: 24 V DC via backplane

Connection: Screw terminal block

Technical Specifications:

Input Current: Typically 5 mA per channel

Response Time: ≤ 15 ms per channel

Test Pulse: Integrated test source (1 ms/2.5 mA)

Operating Temperature: -25°C to +60°C

Storage Temperature: -40°C to +85°C

Protection Rating: IP20 (for control cabinet installation)

Dimensions: 45 x 99 x 61 mm (W x H x D)

Weight: Approximately 100 g

Input Characteristics:

Voltage Range: 0-30 V DC

Logic Level: 0-5 V DC = OFF, 15-30 V DC = ON

Input Delay: Configurable filter time

Cross-circuit Detection: Yes

Short-circuit Protection: Yes

Safety Functions Supported:

Emergency stop devices

Safety interlock switches

Light curtains and safety mats

Two-hand control devices

Enable switches

Safety command devices

Diagnostic Features:

Per-channel status indicators (LEDs)

Input monitoring and diagnostics

Fault detection and reporting

Configuration error detection

Wiring Configuration:

Terminal Type: Screw terminal (0.34-2.5 mm²)

Wiring: Separate for each channel

Isolation: Channel-to-channel isolation

Test Outputs: Integrated test sources

Application Features:

Expandable safety input capacity

Flexible device connectivity

Centralized safety system architecture

Reduced wiring complexity

Simplified troubleshooting

Typical Connection Devices:

E-stop buttons

Safety gate switches

Light curtains and scanners

Safety mats and edges

Two-hand control stations

Manual reset devices

Certifications and Standards:

CE marked

UL listed

cULus approved

TÜV certified

Complies with IEC 62061, ISO 13849-1

EMC Directive 2014/30/EU

Low Voltage Directive 2014/35/EU